bookcases Archives - Page 2 of 2 - Custom Cabinet and Bookcase Design Blog

How to Install a Light Bridge in a Bookcase

08. October 2014 · Write a comment · Categories: Bookcase Installation · Tags: bookcases, bookshelves, built-ins, installation

by Wade Shaddy

Create illuminated space in any bookcase using a light bridge. This type of lighting is installed below any shelf using simple ambient lights to add depth and character to the bookcase. Typical light bridges illuminate objects other than books such as vases, flowers pictures or keepsakes. They serve to open up the bookcase by providing light between rows of books on on either side. Typical light bridges are installed in bookcases that have three sections, with the middle section receiving the light bridge. It’s fine to add a light bridge to any shelf for the same effect.

1. Measure the length horizontally across the top shelf of the bookcase. Purchase a light bridge that will fit between the two vertical sides of the bookcase. The light bridge doesn’t need to fit tight flush on either end. For example, if the shelf is 48 inches wide, use any light bridge fixture measuring between 18 and 36 inches.

2. Stain and lacquer the front of the light bridge if needed. Lots of light bridge fixtures have a single piece of molding across the front. Choose a molding profile that matches your existing trim, and apply stain that matches the existing bookcase.

3. Locate the nearest power outlet. Use a drill/driver and 1-inch Forstner bit to drill a hole through the back of the bookcase on the side needed to access the power outlet. Drill the hole one inch diagonally from the back corner. If the bookcase is installed to the wall, it’s OK to drill the hole through the side of the bookcase, one inch diagonally from the back corner on the side needed.

4. Place the light bridge fixture under the top of the bookcase. Center it flush with the front edge.

5. Hold the light bridge with one hand. Use your other hand to place two 5/8-inch screws in drilled holes on either end of the light bridge. Screw the screws in tight to secure the light bridge to the bookcase.

6. Pull the cord straight back from the light bridge fixture to the point where the shelf contacts the back. Use a hammer to tap one horseshoe nail over the cord to secure it to the back of the bookcase. If the bookcase has no back, or the back is no thicker than 1/4 inch, tap the nail into the underside of the shelf to secure the cord.

7. Insert the end of the cord through the 1-inch hole. Pull it snug. Tap two more horseshoe nails into the cord to finish installing the light. Plug it in. The switch to turn the light off and on may be on the cord or the fixture itself, depending on the model.

Things You Will Need

Stain (optional)
Lacquer (optional)
Light bridge fixture
Drill/driver
1-inch Forstner drill bit
5/8-inch screws
Hammer
Horseshoe nails

You can also place the light bridge on the back of the shelf, which is not recommended because the light is dampened — or you can place it under any shelf to illuminate the shelf below it.

If the top of your bookcase has a decorative trim piece across the front that’s greater than 2 inches wide, you don’t need a light bridge. Purchase hobby lights to fit behind it for the same affect.

Warning: Be careful when drilling through finished wood. Drill from both sides to prevent splintering. Wear safety glasses.

Tips for Arranging & Organizing Bookshelves

23. August 2014 · Write a comment · Categories: Bookcase Design Tips · Tags: bookcases, bookshelves, built-ins

by Lauren Frandsen

Bookshelves do double duty as storage space for books and display space for accessories. Learn how to arrange shelves so they are both fully functional and pleasing to the eye.

Keep It Simple

To style a bookcase to perfection, resist the urge to pack in accessories on every shelf. Keep a clean look by choosing a one-color or tone-on-tone scheme for vases and figurines, and make sure to mix up shapes. Every so often, step back to assess the overall balance of your arrangement. Place items off-center or try larger or smaller ones until you like what you see.

Doorway Savvy

Built-in bookshelves surrounding a doorway can be tricky; start by filling the top row with books. Alternate the remaining nooks with creatively stacked books and accessories.

Everything Fits

To add interest to your book collection, alternate stacking books horizontally and vertically. Bold-color picture frames make great bookends and help photographs stand out on shelves.

Less Is More

Mod shelves call for a sparse look, so group together a small set of books that are all of fairly uniform size. Accessorize with streamlined vases, leaving lots of open space on shelves to let the accessories shine through.

Office Symmetry

To give office shelves an organized feel, gather a wide variety of collectibles and place them between books, creating loose symmetry. If you have a picture frame or square shape in one shelf, mirror it with a collectible of a similar shape and size. In a wall of shelves such as this, it’s important to scatter books here and there to punctuate the look.

Color Smart

Carry your color scheme onto your bookshelf to give the room a sense of unity. Here, accent accessories on the shelves match the light blue wall color. Storage boxes conceal items such as toys and movies that you may not want out in the open.

Outside Interest

Utilize a built-in bookcase as a fashionable and functional headboard. Baskets hold eyeglasses and lotions, leaving plenty of room for a library of nighttime reading materials. Add more appeal with adjustable reading lights mounted inside the bookcase. Hang a favorite piece of artwork on the front of the shelf for visual interest.

Pleasing Prints

Adding wallpaper or printed fabric to the back wall of shelves creates a unique look and is an easy way to personalize a bookcase. Add woven baskets and decorative storage boxes to easily organize magazines and maintain a clean look. Attach fun labels to shelves to establish an organizing system for your books.

Pottery Panache

Use pieces of sturdy pottery as bookends to keep shelves neat. Bookends especially come in handy for paperbacks and slimmer books, which are less likely to stay upright.

Bold Yet Simple

If your book spines lack visual style, paint your bookshelf a vibrant color to make it the focus. To highlight the color even more, choose a single contrasting shade for accessories.

Great Pyramids

Books can be used to create visual interest. Pyramidal stacks on the center shelves contrast the top shelf of entirely vertical books. Layer pieces of art behind shorter books or small accessories such as figurines.

Alternative Arrangement

For a display-worthy bookcase, organize paperbacks in pretty baskets. Group like books together (by author, genre, etc.) and put labels on the baskets so books are easy to find.

Functional Form

Shelves are great tools to keep a craft workroom organized. Slip magazine holders on open shelves to hold loose papers. Storage boxes conceal clutter and can be kept a neutral color to blend in. For a bolder look, cover boxes with printed paper. Use decorative containers and flea market finds to hold paintbrushes or pens and pencils.

Jumbled Perfection

Vary heights and create interest by stacking books horizontally to use as platforms for displaying other objects. Pull together a small bookcase by arranging the top and bottom shelves in opposite ways.

Lovely Layers

Deep shelves give you the luxury to play with layers. Lean plates and artwork along the back of the shelves, and anchor them with books or heavier objects. Place a few small pieces of art near the front of the shelves to give them depth.

Photo Gallery

Turn bookshelves into a family photo zone by lining them with framed photographs. Place small photographs on stacks of books if there’s room for both. If your shelves are deep, try pushing the books to the back and placing photos in front.

Art Focus

Focus attention on a favorite small sculpture by placing it solo on a shelf. Punctuate the display with groupings of books propped up with small vases or matching bookends.

Clean Display

Get the most storage and style out of built-ins by filling the shelves with books; stack them vertically on the lower shelves and keep the top shelves more open. Arrange accessories two or three deep, keeping them fairly symmetrical for a clean look.

Analysis of a Well Styled Bookcase

12. August 2014 · Write a comment · Categories: Bookcase Design Tips · Tags: bookcases, bookshelves, built-ins, design, partition

I truly love to see bookcases in homes because they are the perfect solution for adding storage and style to your surroundings. Books and collectibles on display add warmth and personality to any space, whether it’s a living or dining area, bedroom or home office. To any visitor, a bookcase will communicate what you read, what you collect, and what you love. Bookcases are a window into your passions and pursuits, and an opportunity for you to put your most favorite things on display.

The challenge for most people is how to style a bookcase well. How do you maximize both utility and aesthetic appeal, but also avoid monotony and clutter? Styling a bookcase is an art, but a job easily tackled if you study those done right.

It Starts with the Back

Simple inexpensive bookcases become stunners when their backs are dressed up with paint, fabric or wallpaper. The bookcase below was brought to life with a pattern that accentuates the balanced display of books and collectibles. One of the bookcase options you can get at Highlands Designs is a beadboard back that adds character.

When styled against a backdrop of robin’s egg blue, this collection from the home of model Coco Rochas has visual appeal, and showcases a love of books, antique coffeepots, vases, and glass bottles. Highlands Designs has partition bookcases like this that divides the space into multiple cubes.

via Vogue

Think in Layers

Here is a shelf masterfully styled by Emily Henderson. Notice the balance achieved between the books alternating in placement from left to right with the ceramics poised on the opposite side. The middle shelf repeats the books plus ceramics combination, and also provides the opportunity to display smaller collectibles. Different heights and textures also add to the appeal.

via HGTV

Vary Book Placement

Did you know there are 7 ways to stack books? Karen from The Art of Doing Stuff teaches us how she styled hers in her partition bookcases to break up the columns. Notice how she doesn’t just stick to books, she adds art and natural objects too. And don’t you love that reading chair?

via The Art of Doing Stuff

Arrange Books by Color

Inside this IKEA Expedit, the books are grouped by color, and also displayed both horizontally and vertically. Practical baskets mix with glass bowls, vases and collectibles to form an aesthetically pleasing display on a brightly painted wall.

via Style at Home

Hang Something

There’s no rule you have to keep it all inside. Why not add one more layer of interest? Consider using the framing of the bookcases to suspend a dramatic mirror, framed artwork, or sentimental photographs.

House Beautiful; source unknown

via HGTV

It’s OK to be Single

Smaller cubbies look simply perfect with a textured or sculptural object placed all by itself. Notice the use of a single vase or shell in the smaller spaces of John & Sherry’s bookcase, and the fantastic contrast with bold blue and crisp white.

via Young House Love

Think Oddly

Objects tend to look better when gathered in odd numbers, and the basic design principle of the rule of threes is cleverly applied in this bookcase featured in Lonny Magazine. Notice how most of the books are stacked horizontally, but the bookcase becomes so stylish with the varied and perfectly placed decorative objects, prints, and forward facing book covers.

via Lonny

Varied groupings of three or five are always visually appealing. This bookcase from the home of Lisa Martensen is an example of a well edited display from her treasure hunts and travels all around the world.

via D Magazine

Allow Room to Breathe

With airy shelving, it’s best to not overwhelm and allow for plenty of breathing room around objects. Deliberate use of open space keeps the eclectic collection on this bookshelf from appearing too cluttered.

via Viva Terra

With a little concentration, it’s possible to style a bookshelf well with both books and the things you love. The secret to doing it successfully is truly all in the placement and editing of your favorite objects.

Built-in Bookcase and Mantle Installation

02. August 2014 · Write a comment · Categories: Bookcase Installation, Built-in Installation · Tags: bookcases, bookshelves, built-ins, installation

By Robert Robillard

Installation

This post provides an example of how to install a bookcase, fireplace mantel and the panel above the mantel.

Earlier we prepared the blue stone fireplace mantel and brick corbel supports in order to install a shorter mantel to accommodate a flat screen TV. A new Somerset Mantel will cover and hide the torn off corbels and a larger panel will cover the exposed brick.

In order to get the panel to cover the brick we had to fur out the wall above 3-1/2″ to match the face of the brick. We used 2×4 lumber on edge and Timberlock type lag structural screws to lag the studs to the wall.

We took care to install all of the lags in the same spots on each stud.

The measurements were then recorded for when the TV wall mount is to be installed. There is nothing worse than drilling into a brand new piece of custom work and hitting a screw or lag.

Planning For A Flat Screen TV:

The electrician ran all of the HDMI, cable and power wires and we fished them to the top of our furring strips for easier access later. He will come back and mount boxes for all of the connections. These boxes will be hidden by the TV.

We purposely designed the new bookcase 3/4″ smaller than the one we were trying to match. We did this so we could fur out the wall behind the bookcase to accommodate future speaker or audio visual wires.

Prior to installing the bookcase we also cut out a rectangular slot in the base cabinet to make getting wires from the base cabinet to the rear of the bookcase.

Installing The Fireplace Mantel:

After furring the walls we set the mantel in place. We attached 3/4″ birch plywood scraps to the face of the brick with 2-1/2″ Tapcon screws. The plywood scraps will allow us to nail the mantle to the fireplace.

Both base cabinets had return molding touching the brick so we had to cut the mantle profile out in this molding.

We used a Japanese saw, utility knife and a sharp chisel to carve out the molding and then slid the mantel down.

With the mantle in place we cut installed the panel. Typically a panel this size would have been done as three smaller panels but it was decided that it would be better to have one panel since a large TV was being installed. The panel sits on top of the mantel shelf and was attached with finish screws.

Installing The Bookcase:

The bookcase was then installed. I purposely made the far right side of the bookcase trim larger to accommodate for an uneven or plumb wall. We scribed the wall and used a jigsaw to cut a bevel cut. Bevel cuts help the unit slid in place and are also a lot easier to make miner micro adjustments with a hand plane.

Once the bookcase was in place we secured it through the left side into the panel stud and along the top of the case, and through the back panel on the far right side. Pre-drilling and counter-sinking are important and We filled the screw holes when done.

All nail holes are then filled and sanded, the entire project is vacuumed and then we caulked the seams. We then installed the shelves and re-installed the existing crown molding that we had saved.